How to Program the DSC26103 to your 2GIG GC2 Panel

Introduction

This guide provides step-by-step instructions on how to pair the DSC26103 Z-Wave device with the 2GIG GC2 system. Ensure your device is powered on and ready for pairing.

Steps to Pair Z-Wave Devices with 2GIG GC2

Step 1: Access Z-Wave Settings

Press Services, then press the Z-Wave logo.

Step 2: Advanced Settings

Press the wrench icon for settings, then enter the default installer code 1561.

Step 3: Add Z-Wave Devices

Press Add Devices to enter Z-Wave learn mode.

Step 4: Activate the DSC26103 In-Wall Switch

Use one of the two methods below to activate the DSC26103 in-wall switch:

• Press Include on the remote to begin the Z-Wave inclusion process.

• In a 3-wire system, toggle the external switch/button or push the internal button to initiate pairing into the Z-Wave network.

Step 5: Complete the Pairing

Once the learning process is complete, press Back or Home to exit.

If you have trouble following the steps or need further assistance, contact our support team.