ADC-V520 Indoor Camera Guide

This camera has been discontinued but can still be added and viewed in Alarm.com

Specifications

Warning! Erases everything, camera must be re-added to Alarm.com and WiFi configured

Insert pin into back reset hole for 60 seconds, LED flashes red if successful

1. Hold side WPS button for 5 seconds until LED flashes blue

2. Press and release router WPS button or enable WPS mode in router programming

3. Camera LED turns solid green if successful

Plug Ethernet cable into back of camera and unused port on WiFi network router

Note: the camera must first be connected to Wi-Fi.

2. Select Settings.

002_Brinks_Home_App__Desktop__Video-Live_Video_Default.png

3. Scroll to the bottom of the page and select Add video device.

4. The camera should be detected. Enter the camera name, then select Install.

004_Brinks_Home_App__Desktop__Name_Camera_and_Install.png

5. The camera is added to the network, which can take several minutes.

6. When finished, select Live View to view images from a newly installed camera.

Note: The camera must first be connected to Wi-Fi.

1. Log in to the Brinks Home Mobile App and press Video (found under the menu icon in the top left corner.

2. Select Settings by pressing the Gear icon in the upper, right-hand corner.

3. Select Add video device, then select your compatible device type.

003b_Mobile_App_Select-Device_Clean

4. The camera should be detected. Enter the camera name, then select Next.

5. The camera may take several minutes to configure.

6. When finished, select Live View to view images from a newly installed camera.