ADC-V721W/ADC-V722W Outdoor Camera Guide

This camera is discontinued but can still be added and viewed on Alarm.com account

Specifications

• 1280 x 800 pixel video resolution
• 40' night vision range
• Field of view 62° Horizontal 38° vertical
• WiFi 802.11 b/g/n
• WiFi only
• Operating Temperature -4°F to 122°F

Factory Default

Warning! Erases everything, camera must be re-added to Alarm.com and WiFi configured

Hold back button for 15 seconds until LED flashes red and green

WiFi Setup by WPS Enrollment

1. Hold back button for 5 seconds, LED flashes blue

2. Press and release WPS button on WiFi router or enable WPS mode in router programming

3. After 2 minutes camera LED turns green if successful or red if failure

WiFi Setup by Access Point

1. Hold back button for 6 seconds until LED flashes white

2. Go to smartphone WiFi settings and select ALARM (xx:xx:xx) then press CONNECT

3. Open web browser and enter 192.168.1.1, camera menu appears, select language

4. Press SCAN FOR WI-FI NETWORKS, then select WiFi network

5. Press SECURITY KEY then enter WiFi encryption key then press SAVE then OK to exit

Add Camera using the Brinks Home™ App Website

Note: the camera must first be connected to Wi-Fi.

1. Log in to the Brinks Home App on a desktop browser and press Video.

 

2. Select Settings.

 

3. Scroll to the bottom of the page and select Add video device.

 

4. The camera should be detected. Enter the camera name, then select Install.

 

5. The camera is added to the network, which can take several minutes.

 

6. When finished, select Live View to view images from a newly installed camera.

 

 

Add Camera using the Brinks Home™ Mobile App

Note: The camera must first be connected to Wi-Fi.

 

1. Log in to the Brinks Home Mobile App and press Video (found under the menu icon in the top left corner.

2. Select Settings by pressing the Gear icon in the upper, right-hand corner.

 

3. Select Add video device, then select your compatible device type.

4. The camera should be detected. Enter the camera name, then select Next.

 

5. The camera may take several minutes to configure.

6. When finished, select Live View to view images from a newly installed camera.

 

Troubleshooting

LED Reference Guide

• Off - No power
• Green ON - Internet and Alarm.com connection OK
• Red On - No local or Internet connection
• Red Blink - Factory reset or firmware upgrade
• Red ON - No access to Internet or Alarm.com